Zenit AG-180/1800, Инструкция по эксплуатации

Страница: 8 / 10

8
Maintenance and inspection
1. Inspecting the depressed center wheel.
Confirm that there is no crack or any damage to the depressed center wheel.
2. Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the
screws be loosened, retighten them immediately.
3. Inspecting of carbon brushes
The motor employs carbon brushes which are consumable parts. Replace the carbon
brush with a new one when it becomes worn to its wear limit. Always keep carbon
brushes clean and ensure that they slide freely within the brush.
4. Replacing carbon brushes
Removal
Loose the screw retaining the brush cap.
Use auxiliary wrench or a small screwdriver to pull back the brush spring. Move the
spring edge from the brush holder.
Remove the brush pigtail from the brush holder terminal and remove the brush from the
brush holder.
Installing
- Install the brush pigtail in the brush holder terminal.
- Install the brush into the brush holder.
- Use auxiliary wrench or a small screwdriver to put the spring edge on the top of the
carbon brush,
- Install the cap and tighten the screw D4.
5. Maintenance of the motor
The motor unit winding is the very “heart” of the power tool. Exercise due care to un-
sure the winding does not become damaged and/or wet with oil or water.
CAUTION
When using the screwdriver follow these rules:
• continuous use of the power tool should not exceed 15 minutes;
• do not allow mechanical damage (strikes, falls etc.);
• protect the power tool from external sources of heat and chemically active substances,
as well as liquid and objects penetration;
• before disconnecting the tool from the power source turn off the On/Off switch;
• check the engine temperature, do not allow overheating;
• change the rotation direction only after switching off the tool and complete stop of
rotating parts.
Inobservance of these rules will make warranty void!
WARNING! Repair, modification and check of ZENIT power tools should be