Zenit Powertools SEMI-PROFI Series, Инструкция по эксплуатации, Страница: 6 / 10

6
applications
Rotation and hammering function
• Drilling anchor holes
• Drilling holes in concrete
• Drilling holes in tile
Rotation only function
• Drilling in steel or wood
• Tightening screws
Hammering only
• Wall chasing
• Crushing and chiseling
prior to operation
1. Power source.
Ensure that the power source to be utilized conforms to the power requirements speci-
fied on the product nameplate.
2. After transporting the rotary hammer in winter conditions, before operation indoors it
is recommended to wait 2 hours. Do not switch on the rotary hammer until dried up.
3. «On\Off» switch.
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power switch is in the ON position, the
power tool will start operating immediately, inviting serious accident.
4. Extension cord.
When the work area is removed from the power source. Use an extension cord of suf-
ficient thickness and rated capacity. The extension cord should be kept as short as prac -
ticable.
5. Installing the drill bit.
To install the drill bit pull the grip and insert the greased bit end into the chuck. Release
the grip. The tool should be secured in its place.
To remove the tool, fully pull the grip and remove the tool. The same way the drill chuck
and chuck adaptor are installed.
6. Drilling depth can be adjusted with a depth gauge.
Selecting the appropriate drill bit.
When boring concrete or stone use a concrete drill bit.
When boring metal or plastic use an ordinary metalworking drill bit.
When boring wood, metal or plastic use an ordinary metalworking drill bit.
WARNING! Always attach the side handle.
WARNING! Do not use the Impact Drill in the IMPACT function if the material