ZENEC ZEM-W652U, Инструкция по эксплуатации

Страница: 14 / 20

14
5. INSTALLATION
NOTE: It is recommended that the installation of
this monitor is carried out by qualified persons,
to achieve reliable function and best picture
quality.
Step
B
-
Set up your work area
Remove the headrest and put it down in an
uncluttered and clean working area. Take
appropriate precautions to ensure that the head-
rest is not damaged during the installation.
Step
C
-
Take measurements
Push on the headliner with your Fingers to make
sure there are no obstructions that would hinder
the installation. Use the paper template and a
felt tip marker pen to mark the area to be cut.
Step
D
-
Carefully cut the headrest
Using an adjustable-depth Japan knife or carpet
cutter blade, start your cut 1/4 inch inside one
corner and cut diagonally across, stopping 1/4
inch in front of each corner. Repeat the procedu-
re for the other two corners.
Step
E
-
Remove foam and other obstruc-
tions behind the cut
Carefully peel back the leather or vinyl materi-
al. Set the adjustable blade to one inch depth
and cut in a straight line along the edges of the
hole, staying 1/4 inch inside the edge. Pull up
one corner of the foam and use the blade to cut
underneath. Remove small sections at a time,
using the pull up and cut method for a uniform
depth. Use a Dremel or another appropriate tool
to remove other obstructions. Insert the headrest
bezel to measure the fit and make adjustments
if necessary.
ZEM-W652U Manual D+E.indd 14 24.09.2004 16:15:52 Uhr