5
DEVICE OPERATION:
The Receiver module (RX) and the Transmitter module (TX) out of the same box have been paired
before packing.
If you need to pair the modules again, long press the pairing buttons of RX- and TX-module at the
same time for over 2 seconds, the LED status lights will be flashing slowly. When pairing succeeds,
the LED´s will stop flashing.
If the LED status lights are flashing fast, both modules are in transmission mode. This means the
RX- and TX-module are paired correctly and video and audio signal is transmitted.
If no signal is transferred, the ZE-RVTX will change automatically to a standby mode. The LED
status lights stays permanently on. The LED indicator light is also permanently on if the:
• RX- and TX-module is not paired correctly.
• RX- or TX-module is powered off.
• TX-module didn´t detect a video or audio signal.
CAUTION
• Make sure that there are no bigger electrical components in the immediate vicinity of the
TX- and RX-module, so that the power level of the signal transmission is not impaired.
• The modules are only conditionally dustproof and have been licensed according to the
international standard IP53. Due to this, both modules should only be installed inside the
vehicle.