ENGLISH
15
2. INSTALLATION
2.1 GENERAL
■
Do connect the ZE-DVB2000 with a suitable active antenna (e.g. ZE-TV-DVBA1) with the
antenna in of the unit.
■
Do connect the ZE-DVB2000 with a suitable RCA video-cable the video output of the
ZE-DVB2000 with your headunit/monitor.
2.2 IN COMBINATION WITH A NON ZENEC „DVB-T READY“ UNIT:
■
Do connect the power supply harness with a suitable voltage supply source.
Yellow cable:
Constant power, b12V (B+).
Red cable:
Switched power (ACC), connect this cable with the REM output of
your headunit or with any other switched power supply of your car.
GND:
Ground (GND).
■
Do connect with a suitable RCA audio-cable the audio-output of the ZE-DVB2000 with
your headunit/monitor.
■
Install the IR receiver at a suitable place that you can operate with the remote control. Do
connect this with the IR in of your ZE-DVB2000.
2.3 IN COMBINATION WITH A ZENEC „DVB-T READY“ UNIT:
■
Do connect the DIN/DIN cable with your ZE-DVB2000 and your ZENEC „DVB-T ready“
unit. This cable provides the power supply, audio signals and operation signals. You do
not have to connect the power supply harness, the IR receiver or the audio RCA cable.