ZENEC Z-E2050, Руководство по установке устройства

Страница: 3 / 7

3
● The installation of the ZENEC system should be carried out by an authorized installer. Specific
knowledge and tools are required to do the installation. Incorrect installation can cause damage to the
vehicle and the ZENEC system.
● Correct functioning can only be guaranteed when you use the ZENEC original accessories included
in the kit or those optionally available. The ZENEC system and the original accessories must under no
circumstances be modified or altered in any way. Inappropriate actions can cause damage to the
vehicle and the ZENEC system.
●
Torx screwdriver T25
●
Release tool made of plastic
●
Insulating tape
●
The target vehicle must factory configured with one of the OE radio or navigation systems, listed
on the previous page. The ZENEC system is not compatible with vehicles, which are equipped with a
hybrid or electro drive ex factory.
●
This device installation manual applies to vehicle platforms appearing in the compatibility list on the
previous page, and in a condition as offered by the respective vehicle manufacturer. Other differing
configurations and installations may result in complications and malfunctions.
●
The ZENEC system is equipped with an integrated DAB+ receiver. To make use of this you will need
a suitable DAB antenna (not included in kit) that must be connected to the ZENEC system.
● If the target vehicle is already equipped with an original DAB antenna, it is still possible to use it in
combination with the ZENEC system. Please use the DAB antenna connector (No. 6), which is part of
the kit, for connection.
● The Z-E2050 comes with an adaptor interface, which fits to the double FM antenna plug from the
vehicle. If this solution is not sufficient, e.g. the FM radio reception is deemed to be poor, the
ZE-NC-ANT3 phantom power adaptor which is separately available, may help to improve FM signal
level.
●
Software updates to the ZENEC system are installed with a USB memory device. Therefore when
fitting the system make sure that the USB connection of the ZENEC system will still be accessible
later (installation of USB extension cable or USB hub).
●
If you have questions or problems relating to the ZENEC system, please contact the dealer from
whom you purchased it.
●
Additional questions about the compatibility could be answered by using the ZENEC online
configurator:
www.zenec.com/configurator
TOOLS REQUIRED
No. Article Qty
1 ZENEC system 1
2 GPS antenna 1
3 Double-sided adhesive pad 1
4 Main connection cable Quadlock II 1
THE KIT INCLUDES
5
CAN bus interface 1
6
DAB antenna adapter (Fakra – SMB) 1
7
USB extension cable
1
8
24-pin connection cable (4.2, Cam, Mic)
1
9
FM antenna adapter (Single to twin Fakra)
1
●
ZENEC ZE-NC-ANT3 (antenna interface)
●
DAB antenna with SMB plug
(e.g. Z-EACC-DAB1 or Z-EACC-DAB2)
●
External microphone (N-ZENC-MIC)
ADDITIONAL MOUNTING ACCESSORIES
CAUTION
NOTE