1.
Insert spigot through bottom tank with 1 o-ring
on each side of the tank (see inset). Tighten
spigot with magnetic nut as much as possible.
2.
Place cleaned mineral stones inside bottom
tank. Place bottom tank on the base.
3.
Place the middle ring on the bottom tank.
4.
Screw cartridge ring onto 5-stage filter cartridge.
Then place onto middle ring.
5.
Un-screw wing nut and o-rings from stem of
ceramic filter. Insert stem of ceramic filter
through the top tank with 1 o-ring on each side
of the tank. Tighten dome with nut.
6.
Place top tank on middle ring. Cover with lid.
1.
Un-screw o-rings and nut from float valve.
I
nsert float valve through hole in bottom tank
with 1 o-ring on each side of the tank.
2.
Place bottom tank on water cooler or dispenser.
(
If float valve is too large to fit into dispenser,
see FAQs on page 4.)
3.
Place cleaned mineral stones inside bottom
tank. Place middle ring on bottom tank.
5.
Screw cartridge ring onto 5-stage filter cartridge.
Then place onto middle ring.
6.
Un-screw wing nut and o-rings from stem of
ceramic filter. Insert stem of ceramic filter
through the top tank with 1 o-ring on each side
of the tank. Tighten dome with nut.
7.
Place top tank on middle ring. Cover with lid.
Ceramic o-rings (2)
Spigot o-rings (2)
Magnetic Nut
Ceramic o-rings (2)
Float Valve o-rings (2)
Important: Check for leak around the spigot (
Countertop model only
). If there is a leak,
simply tighten the magnetic nut. A leak should not occur if the nut is properly tightened.
Do not use unit if a leak is detected.
Allow one full upper tank to filter through to lower tank before consumption.
Discard the first tank of water.
The
first couple of tanks may take up to a few hours to completely filter through the
cycle. Flow rate will gradually increase after a few days of use. (See FAQs on page 4
if it takes longer than 5 to 7 hours to drain the first tank.)
Wing Nut
Wing Nut
