Zen One
ASSEMBLY INSTRUCTIONS
Component Checklist
Model:
23 Series
1
WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL
ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS AND
WARNINGS REGARDING THE USE OF THIS PRODUCT MAY
RESULT IN SERIOUS BODILY INJURY.
WARNING
product is not intended for use by young children without supervision.
This product contains small items that could be a choking hazard if swallowed. Keep these items
away from children.
This product is intended for indoor use only. Using this product outdoors could lead to product
failure and personal injury.
IMPORTANT:
Ensure that you have received all parts according to the component checklist prior
to installation. If any parts are missing or faulty, telephone your local distributor for a replacement.
This
This product can be used by children from 8 years old (supervised) to Adult. Users with disabilities
or lack of experience and operating knowledge should be supervised and given careful instruction
prior to using this product. The desktop should never be sat on and children should be prohibited
from having unsupervised contact with the product.
Cleaning and user maintenance shall not be made by children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid a hazard.
CAUTION:
·
Please place the product away from corrosive gas, water and dusty environment.
·
Please do not disassemble all the components, otherwise, it will be seen as the withdrawn of
the warranty service.
QUICK TIP: DO NOT overtighten screws during installation.
Tools
Needed
Important information
Read the entire instruction manual before you start
installation and assembly.
Disposal:
This marking indicates that this product should not be disposed with other household
wastes. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this product for
environmental safe recycling.
A
telescopic crossbar
(x1)
D (x2)
foot
C (x1)
shelf
E (x2)
side bracket
H (x1)
leg
Assembling the Frame
F
hook
(x2)
B (x1)
sync rod
S-A (x16)
S-C (x2)
S-D
Allen key
(x1)
S-E
cable clip
(x3)
S-B (x10)
·
Attach the telescopic crossbar to the legs as shown
using the screws identified in the illustration.
·
Loosen the two screws using the Allen key.
·
Adjust the frame length to suit the desktop.
·
Retighten all screws.
A
I (x1)
leg
J
adapter
(x1)
·
Tighten all screws with a proper screwdriver.
2
Installing the Side Brackets
·
Attach the two side brackets to both ends of the frame
using the four screws and tighten all screws with an Allen key.
3
Installing the Feet
·
With the frame upside down, place the feet on the legs as shown.
·
Insert the screws as shown and fix them under the desk legs.
G
control unit
(x1)
H
I
S-A
D
S-A
S-A
E
S-F
rubber pad
(x6)
