6. Pull the fly over the inner tent. The
ORANGE
webbing loops indicate the
front of the fly. Connect the velcro
loops inside the fly around the cut
outs on the corresponding pole
sleeve.
5.
Peg out all the peg points around
the inner tent. The peg points at the
base of each pole should be
pegged through the webbing loop
rather than the ring. Attach the C
clips around the poles.
2x
2x
4.
Thread the
BLUE
poles through the
BLUE
trimmed pole sleeves at the front
and rear of the tent. Insert the ends of
the poles into the pins located below
each pole sleeves. Clip the C clips
around the poles
8.
Attach the elastic loop over the
existing inner pegs. Where there is
no existing peg, peg the fly directly
into the ground ensuring there is
significant space between the inner
and fly.
9.
It is recommended that guy
ropes are pegged out at all times
and windows are opened whenever
possible to allow adequate
ventilation.
Insert pegs at a 45
o
angle
3.
Thread the
RED
poles through the
RED
trimmed pole sleeves that run
diagonally across the centre of the tent.
Insert the ends of the poles into the pins
located below each pole sleeve. Attach
the C clips around the poles
1.
Clear your site making sure there are no
sharp objects where you are going to pitch
your tent. Try to get a site that is as flat as
possible. Spread out the inner tent (White),
the floor extension is located
at the front.
2.
Assemble the 5 pole sections.
Ensure that the poles do not snap
together.
1x
7.
Thread the remaining
GREEN
pole
through the pole sleeve on the front of
the vestibule fly. Insert the pins at the
base. The webbing strap between the
pole ends should sit under the inner floor
and the floor hooks should attach to the
ring pins.
8.
6.
Pull the fl y over the inner tent. The
ORANGE webbing loops indicate the
front of the fl y.
7.
Connect the Velcro loops inside the
fl y around the cut on the corresponding
pole sleeve.
9.
10.
2.
Assemble the 5 pole sections. Ensure
that the poles do not snap together.
It is important that the poles are
fully inserted into the ferrules. If not
connected correctly they can cause
damage when tensioned.
Attach the C clips
around the poles.
Insert the pole ends
into the pins located on the steel rings
at the base of the tent. Attached the
c-clips around the poles.
Insert the pole ends into the pins
located on the steel rings at the
base of the tent. Attached the
c-clips around the
poles.
steel ring. Attach
the C-clips around the poles.
