INSTRUCTIONS
2.
Assemble the 2 pole sections. Ensure
the poles are insterted firmly together.
It is important that the poles are fully
inserted into the ferrules. If the ferrules
do not connect together correctly they
can cause damage when tensioned.
8.
Peg out all peg points and guy
ropes, pegging at a 45
o
angle.
7.
Connect the fly to the inner by
connecting the side release buckles at
the end of each pole line.
1x
3.
Thread the
GREY
pole through the
front
GREY
trimmed pole sleeve that
runs above the door at the front of the
inner tent. Tension the pole inserting
the ends of the pole into the eyelets
located on each side of the tent.
The
second eyelets allow for extra tension
depending on your pitch.
1.
Clear your site making sure there are no
sharp objects where you are going to pitch
your tent. Try to get a site that is as flat as
possible. Stretch out the inner tent.
1x
6.
Throw the flysheet over the inner
and fasten the Velcro ties found on
the inside of the fly around the pole
lines.
4.
Thread the remaining
RED
pole
through the
RED
trimmed pole sleeve
that runs across the rear of the inner
tent. Tension by inserting the ends of
the pole into the eyelets located on
each side of the tent.
5.
Peg out the inner tent. Try to
tension the floor so that it sits flat.
2.
Assemble the 2 pole sections. Ensure
the poles are insterted firmly together.
It is important that the poles are fully
inserted into the ferrules. If the ferrules
do not connect together correctly they
can cause damage when tensioned.
8.
Peg out all peg points and guy
ropes, pegging at a 45
o
angle.
7.
Connect the fly to the inner by
connecting the side release buckles at
the end of each pole line.
1x
3.
Thread the
GREY
pole through the
front
GREY
trimmed pole sleeve that
runs above the door at the front of the
inner tent. Tension the pole inserting
the ends of the pole into the eyelets
located on each side of the tent.
The
second eyelets allow for extra tension
depending on your pitch.
1.
Clear your site making sure there are no
sharp objects where you are going to pitch
your tent. Try to get a site that is as flat as
possible. Stretch out the inner tent.
1x
6.
Throw the flysheet over the inner
and fasten the Velcro ties found on
the inside of the fly around the pole
lines.
4.
Thread the remaining
RED
pole
through the
RED
trimmed pole sleeve
that runs across the rear of the inner
tent. Tension by inserting the ends of
the pole into the eyelets located on
each side of the tent.
5.
Peg out the inner tent. Try to
tension the floor so that it sits flat.
