11
PL
EN
CHARGING THE DEVICE
Before using your beard trimmer for the first time, charge for 2-3 hours, and charge 2
hours regularly. Ensure the product is switched off. First insert the plug on the end of the
USB charging cable lead into the unit (Fig. 1) and then connect the USB charging cable
to the USB interface. This appliance is suitable for 5V DC Max 1A charger, computer and
other power interface (Fig.2).
The charging indicator icon will flash on the LCD display when it’s charging and when
it’s fully charged it will show 99. The display will always show the remaining battery level.
Your groomer cannot be overcharged. However, if the product is not going to be used for
an extended period time (2-3 months), unplug it from the mains and store. Fully recharge
your hair clipper when you like to use it again.
To preserve the life of your batteries, let them run out every 6 months then recharge for
2-3 hours again.
HOW TO MATCH THE APPLIANCE
Remove out the attachments by pulling upwards by hand (Fig. 3-4).
First align the bottom part in the right position, then move upwards to lock and press.
Choose between different heads to get different hair styles (Fig. 5-12):
- T-Blade head (1): to taper the beard/moustache and to hair head cut.
- Design trimmer (4): to define the beard/moustache line and sideburns.
- Precision trimmer (5): to trim the nape of your neck, beard/moustache.
- Nose&ear head (6): to remove hair from nostril and ears. Important: avoid inserting the
cutting unit more than 6mm into your nostril or ear.
- Micro shaver (7): to shave your face. Important: hold the groomer in a 45 degree angle.
- Body groomer (8): to remove or cut the hair from your body.
Prior to turning the device on, select the desired comb guide fitting it by pushing forward
in a proper way (Fig. 13-14). Choose between different levels of matching comb to cut hair
of different lengths (9-11). The length of the cut is indicated on each limit comb as follows:
NUMER
LENGTH (mm)
SUITABLE FOR
A
3
T-BLADE HEAD
B
6
T-BLADE HEAD
C
9
T-BLADE HEAD
D
12
T-BLADE HEAD
E
1-2-3-4 mm
PRECISION TRIMMER
F
3/6/9 mm
BODY GROOMER
If the hand combing needs to be replaced, pull upwards by hand. Open the bottom end of
the comb lock and push forward (Fig. 15-16).
