Zelmer 481.4, Руководство по обслуживанию

Страница: 24 / 32

24
2. DISASSEMBLY OF MIXER PARTS
The disassembly should be carried out on a table covered with clean felt or other soft
material, taking care not to scratch the parts made of plastic.
2.1 Disassembly of the drive type 481.0000 (Fig. 1)

Using a screwdriver, remove the three screws 18 securing together the halves of the mixer
housing (after removing the screws both halves are held together only by snap fasteners
located in the lower portion of the housing).

Place the mixer on the table, with the right housing 1 facing downwards.

Holding down with one hand the right housing with the attached power cord 9 , remove the left
housing 2 (taking care not to perform this operation in a reverse order, as this might cause
damage to the internal wiring due to the motor dropping out!).

Remove the pusher 4 and the slider 3 from the right housing 1 .

Slide the switch cpl. 5 off the guide, disconnect its wire connections to the motor stator and
unsolder the internal power lead.

Take out the motor, removing the rubber shock absorbers 7 from it.

From the motor bearing disc remove the two screws 19 securing the threaded end 8.

Slide the special joint 6 off the housing guide, pulling up the power cord 9 simultaneously.

Unsolder the discharge resistor 12 , take the capacitor wires out of the special joint grooves.

Unsolder all the wires of the special joint. Disconnect the connection of the special joint 6 to
the motor stator.
2.2 Disassembly of the stand with bowl type 481.1000 (Fig. 3)

Press the catch pusher 3 and pull back the base articulated 2
together with the “head”.

Pull out the spatula 8 , and then remove the bowl 12 from the stand base 1 .

Remove the grip knob 6 from the hole in the protrusion of the upper part 5 .

By means of a screwdriver, release the base articulated 2
together with the “head” from the
two arms of the base 1 .

Turn around the stand and by means of a screwdriver squeeze the two elastic catches in the
pusher and push out the catch pusher 3 together with the spring 15 . Remove the five
supports 16 from the base.

By turning the gear wheel 11 set the
“head” in such a position that the two holes for the
screws securing the head plate 4 to the upper part 5 are exposed.

Remove the four screws 17 . Turn around the whole unit and remove the upper part 5, take
out the gear wheel 9 and 10 , and then the gear wheel 7 .

Set the head plate 4 in such a position relative to the base articulated 2 that the base catches
are aligned with the base articulated openings and disconnect both parts. Pull out the gear
wheel
11 from the base articulated 2 .