Zektor HDS4, Руководство пользователя, Страница: 4 / 20

4
1 2
3
4
5
6
7
8 9
0
PIP ENT
TV VCR
CBL /
SAT DVD RCVR
POWER
VOL
CH
+ +
_ _
Using the HDS4 with a Remote Control
Operation of the HDS4 is done fully through the use of a universal remote control. A remote control
is not supplied with the HDS4, yet the versatile programming modes of the HDS4 allows the HDS4
to work with virtually any remote control. The next section "Programming your Remote Control" on
page 5, describes how to setup your remote controller. After your remote control is programmed the
following describes the pre-programmed functions of the HDS4.
There are 10 separate remote controlled commands understood by the HDS4. They are:
•
P
OWER
T
OGGLE
.The HDS4 can be toggled from standby to power
on, and back to standby using a single button of the remote.
•
S
ELECT
I
N
1
. Select input 1. If the HDS4 is in standby mode, it will
power on and then select input 1.
•
S
ELECT
I
N
2
. Select input 2. If the HDS4 is in standby mode, it will
power on and then select input 2.
•
S
ELECT
I
N
3
. Select input 3. If the HDS4 is in standby mode, it will
power on and then select input 3.
•
S
ELECT
I
N
4
. Select input 4. If the HDS4 is in standby mode, it will
power on and then select input 4.
•
P
OWER
OFF
. The HDS4 can be set to standby mode by pressing a
single button of the remote. Once the HDS4 is in standby mode, fur-
ther presses of the
P
OWER
OFF
button will be ignored. This com-
mand is useful when using the “macro” feature of some
programmable remote controls, and is used when it is unknown
whether the HDS4 is already in standby mode or not.
•
P
OWER
ON
. The HDS4 can be powered on from standby by pressing
a single button of the remote. Once the HDS4 is power on, further
presses of the
P
OWER
ON
button will be ignored. This command is
useful when using remote controls that allow “macro” programming,
where it is unknown whether the HDS4 is already power on or not.
•
S
ET
D
IM
M
ODE
. Toggles through three different bright/dim display
modes. They are: Bright all the time. Dim all the time. Bright for 4 sec-
onds after any keypress, and then automatically dim.
•
S
ELECT
+
. Select the next higher input. If input 4 is currently selected,
then this command will cause input 1 to be selected.
•
S
ELECT
-
. Select the next lower input. If input 1 is currently selected,
then this command will cause input 4 to be selected.