HD800V2 Serial Protocol, Version 1.2, 9/11/13
35
Advanced Control
Response String:
There is no response string to the FS command, this command is write only.
Where ‘settings’ is a bitmapped parameter defined as:
Bit-0
- Reset zone input/output mappings, and power state
Bit-1
- Reset switching delay times
Bit-2
- Reset LED levels and mode
Bit-3
- Reset control settings (the XS command settings)
Bit-5
- Reset IP parameters
Bit-15
- Reset HDMI settings: Clear EDID and HDCP caches, clear HDCP key counts and the EDID lock state.
Note: The HD800V2 must be turned on before sending the “Reset HDMI settings” (Bit-15), and the
switch must be power cycled (using the ‘P 0’ and ‘P 1’ commands) before the cleared settings take
affect.
All other bits are reserved and should be set to 0 when issuing this command.
‘LI’ Lighting Mode and Intensities
This command uses a bitmapped parameter. Each bit can set or reset without affecting the other bits.
(See: “
Using Bitmapped Parameters
” on page 27, for more information on using bitmapped parame-
ters.)
Allows changing the behavior of the front panel LEDs, and adjusting their intensities.
^LI
mode
,
dim
,
bright
,
off
$
Set mode and intensities
^LI ?$
Query for current settings
Response String:
^=LI
mode
,
dim
,
bright
,
off
$
Set mode and intensities
Where:
mode
= Lighting mode (Settings: 0=Off, 1=Dim, 2=Bright, 3=Auto-dim)
dim
= Intensity of dimmed LEDs (Range: 0-100)
bright
= Intensity of brightened LEDs (Range: 0-100)
off
= Intensity of the standby power LED (Range: 0-100)
Response Example:
^=LI 3,020,090,010$
Mode=Auto, dim=20%, bright=90%, off=10%
The mode settings allow you to set the front panel LEDs to always be: 0 - off, 1 - Always at the ‘dim’
intensity, 2 - always at the ‘bright’ intensity, or 3 - auto-dim from ‘bright’ to ‘dim’ when the front panel
is not in use.
The intensities range for 0, which of off, to 100, which is full intensity.
When setting parameters, not all parameter have to be present, if a parameter is not present, it will be
left unchanged. For instance to change just the ‘bright’ value to 50%:
^LI ,,50$
->
Set the ‘bright’ intensity to 50%
Only the ‘bright’ intensity is affected.
Value
32768
16384
8192
4069
2048
1024
512
256
128
64
32
16
8
4
2
1
Bit
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
