Zeiss Transillumination top 450 mot., Руководство по эксплуатации

Страница: 14 / 18

SET-UP
Carl Zeiss Connecting the Transillumination top 450 mot.
14 435500-9000-701 08/2012
3.3 Connecting the transillumination
top 450 mot.
Connecting to the microscope system
•
Use the CAN cable RJ 45 to connect the
CAN
(Fig. 4/ 3 ) socket of the transillumination top to
one of the
CAN
sockets on the rear side of the
focusing motor 3 (Fig. 1/ K ) or the EMS 3
(Fig. 1/
O
).
•
A BNC cable can be connected to the Trigger
(Fig. 4/ 2 ) plug-in point to transmit a trigger
signal.
•
Alternatively, the foot switch S can be used to
switch the illumination of the transillumination
top on/off via the
Foot switch
(Fig. 4/
1
) plug-in
point.
Connecting to the mains supply
•
Connect the power supply unit to the 24V DC
(Fig. 4/
4
) plug-in point.
•
Plug the power cable of the PSU into a mains
socket.
Upon connection to the mains supply the
transillumination top will initialize itself
automatically.
Fig. 4 On/off switch and ports on the
transillumination top 450 mot.