ZEISS
Start-Up and Operation
Primovert
44
415510-7244-001
12/2014
A spare bulb (Fig. 36/
5
) can be placed in the transmitted-light illuminator with halogen bulb
and remain there during the operation.
The transmitted-light illuminator with LED has to be replaced completely. The LED alone
cannot be replaced.
•
Push the transmitted-light illuminator (e.g. transmitted-light illuminator with LED, Fig. 36/
6
) into the
stand and fasten it with the two screws (Fig. 36/
7
). In doing so, slightly press the screws against the
spring and turn them by 90°: Turn right and left screw counterclockwise.
•
Attach the cover (Fig. 36/
1
) again to the stand and let it snap into place.
3.9.2
Attaching a Camera to the Stand
with Binocular Phototube
You can attach a digital camera, a video camera or
a compact digital camera of your choice to the
microscope with binocular phototube using the
four available camera adapters (see Section 2.1).
•
Loosen the clamping screw (Fig. 37/
7
) and
remove the dust cap from the camera port
(Fig. 37/
8
) of the binocular phototube.
Attaching a Compact Digital Camera
•
Sliding mount (Fig. 37/
4
), thread adapter ring
M37/52 (Fig. 37/
3
) and lens mount (Fig. 37/
6
)
are supplied pre-assembled as Digital Camera
Adapter P95 M37/52x0.75. The opposite
drawing shows this unit dismantled.
Furthermore, you may unscrew the thread
adapter ring M37/52 (Fig. 37/
3
) from the sliding
mount (Fig. 37/
4
) (not shown) so that you can
also attach cameras with M37 thread.
•
Mount the adapter ring (Fig. 37/
2
) (optional
accessory for the corresponding camera) to the
camera (Fig. 37/
1
) (see the operating
instructions of the camera).
•
Screw the unit consisting of sliding mount (Fig. 37/
4
), thread adapter ring M37/52 (Fig. 37/
3
) and lens
mount (Fig. 37/
6
) into the adapter ring (Fig. 37/
2
).
•
Insert the camera with adapter into the phototube as far as it will go. Align it and fasten it with the
clamping screw (Fig. 37/
7
).
Fig. 37
Attaching the camera
