Zeiss OPMI Lumera i on floor stand, Инструкция по эксплуатации

Страница: 93 / 178

OPMI Lumera
®
i on floor stand Operation
Version 9.2
G-30-1720-en
Page 93
Powering system up/down
Requirements

The correct rated voltage has been set on the stand (see page 54).

The power cable is connected (see page 80).

The optical fiber is connected (see page 76).

The foot control panel is connected (see page 81).
Proceed as follows to power the system up and down:
•
Press the power switch (1) on the stand.

The system is switched on if the green lamp in the power switch is lit.

After power-up, the system performs a self-test.
During this time (approx. 120 seconds), a start screen with the ZEISS
logo is displayed on the 5.7
″ control panel.
At first start-up of the surgical microscope, the system displays the default
user profile “Default User”. During subsequent log-ins, the system makes
settings for the last user selected.
The “Default User” cannot be edited or changed.
Before using the system, you must perform a functional test (see next page).
During this test, you can check the device configuration and user-specific
settings and reconfigure them if necessary.
CAUTION Increased leakage current!
There is a risk of the user and the patient sustaining an electric shock.
•
Never touch the contacts of connectors during contact with the patient.
•
Do not connect any defective or unapproved accessories to the contacts
of connectors.
CAUTION Risk of injury caused by defective components!
If the software control fails, you must not work with the device for safety
reasons.
•
Inform ZEISS Service.
1