Zeiss OPMI Lumera i on floor stand, Инструкция по эксплуатации

Страница: 76 / 178

Preparations for use OPMI Lumera
®
i on floor stand
Version 9.2
Page 76 G-30-1720-en
Connecting light guide to surgical microscope
Before using the system, check whether the light guide has been connected
to the surgical microscope. If this is not the case, connect the light guide to
the surgical microscope as follows:
•
Switch off the illumination system.
•
Insert the correct end of the light guide into the light guide socket (2) of
the surgical microscope as far as it will go.
Always make sure before surgery that both the primary lamp and the backup
lamp are intact.
Fig. 24: Connecting the
light guide
NOTICE Risk of damage to the light guide!
•
Please note the label under the light guide socket for the correct connec-
tion of the light guide (1).
•
Make sure that the light guide (1) is routed with sufficient slack so that it
is not stretched or bent when the microscope is turned or tilted.
1 2