Zeiss OPMI Lumera i on floor stand, Инструкция по эксплуатации

Страница: 20 / 178

Version 9.2
Page 20 G-30-1720-en
Safety measures OPMI Lumera
®
i on floor stand
Requirements for operation
ZEISS Service or an expert authorized by ZEISS will install the system.
Please make sure that the following requirements continue to be met
for further operation:

The connecting components have been properly connected. The screw
connections have been firmly tightened.

All cables and plugs must be in perfect working condition.

The voltage set on the system corresponds to the rated line voltage at the
site of installation.

The power cord has been plugged into a power outlet which is properly
grounded.

The device is connected with the power cord supplied.
Before every use
•
Make sure that all functional tests prior to use are performed, and the
requirements specified above fulfilled.
•
Go through the checklist in the section “Operation” (see page 95).
•
Comply with all symbols, instructions, and labels on the device.
•
Never cover any ventilation openings.
•
Press the locking tabs on the stand base
to secure the stand in position. Make sure that the floor stand is stable and
cannot roll away.
•
Check that the movement of the surgical microscope is unobstructed to
avoid any collisions and damage to cables.
•
Check the user settings in the software to avoid unexpected behavior of
the system.