Zeiss OPMI 1FR XY, Инструкция по эксплуатации

Страница: 90 / 114

90
Maintenance / Further information
G-30-1416-en OPMI® 1FR XY Surgical Microscope on S7 Floor Stand Issue 4.0
Printed on 14. 11. 2007
Changing the halogen lamp
Warning!
If you change the lamp shortly after it has failed, the lamp will still be very
hot. Wear heat-protection gloves to avoid burns!
Note:
If both halogen lamps (3 and 4) fail during surgery, insert a backup lamp
module. Always make sure before surgery that both halogen lamps in the
installed lamp housing are intact.
To change the lamp, proceed as follows:
• Turn off the unit at the power switch.
• Press button (2), the lamp module is slightly ejected. Pull out lamp
module (1).
• Remove the defective halogen lamp from the spring-loaded mount.
• Pull ceramic base (7) from the contact pins of the halogen lamp. Plug
ceramic base (7) onto the contact pins of the new halogen lamp.
• Insert the new halogen lamp. Make sure you do not touch lamp bulb
(6) or the interior of reflector (5).
• Press the halogen lamp into the spring-loaded mount.
• Push the lamp module including the new halogen lamp back into the
unit.
• Turn on the unit at the power switch .
Notes:
–
Only use 12 V, 100 W halogen lamps available under the specified
Cat. No.: 38 00 79- 9040
– To use the service life of your halogen lamps as economically as pos-
sible, we recommend that you proceed as follows: If main lamp (3) has
failed, remove it and replace it by backup lamp (4). Install the new hal-
ogen lamp instead of the backup lamp.