Zeiss MMZ M, Руководство по эксплуатации

Страница: 113 / 154

Probing the workpiece
61211-1270302 MMZ M
7-21
v
v
1
Probing speed as a function of the joystick deflection
v Travel speed
v
1
Probing speed; optimum travel speed during probing.
With full deflection of the joystick, the maximum possible travel speed is
reached which can be reached in the MAN operating mode. The actual
travel speed depends on the default value defined in the measuring soft-
ware and the position of the control knob on the control console.
Proceed as follows:
1 Enter a default value of 100 % in the measuring software.
2 Adjust the travel speed using the control knob on the control con-
sole.
If the control knob is turned clockwise as far as possible, the maxi-
mum possible travel speed corresponds to the default value, e.g.
100 %, defined in the measuring software.
The control knob makes it possible to reduce the travel speed to
zero. If the travel speed reaches a value of less than 10 % of the de-
fault value, this will be indicated on the control console. An LED on
the standard control console lights up.
—
If the probing speed is too high for certain probing operations, re-
duce the maximum possible travel speed.
NOTE
When probing oblique workpiece surfaces at an angle between 30° and
50°, the probing speed should be reduced.
Particularities of probing systems
For the various probing systems, certain points must be observed: For
more information, please refer to the separate brochure »Sensors«.
Preventing measuring errors
Measuring errors may have several causes. Answer the following ques-
tions before starting the measurement: