26
Lamp replacement and calibration - Corona process | Service manual |
EN_40_070_0010I
Replacing halogen lamps
Lamp replacement and calibration Corona process
2
Loosening the lamp holder
Disconnect the lamp cable with socket
1
from the device.
First remove only three of the four screws
2
from the base of the lamp.
Do this using a TX 25 screwdriver.
To avoid contact with the light guides
4
, secure the lamp holder
3
in
place and remove the fourth screw.
Fig. 23
3
2
4
1
Unscrewing the lamp holder – lamp type B
3
Removing the lamp holder
Carefully remove the lamp holder of the default lamp
1
by lifting it
upwards. Ensure to not touch the light guides
2
underneath.
Fig. 24
2
1
Removing the lamp holder – lamp type B
