18
Lamp replacement and calibration - Corona process | Service manual |
EN_40_070_0010I
Replacing halogen lamps
Lamp replacement and calibration Corona process
6
Removing the system cables
Loosen the union nuts of the connected plugs by hand (or using a 22 mm
spanner) and remove the cables from the device.
Fig. 13
3
2
1
Removing the system cables
“ETHERNET” port
“Digital IN OUT” port
“POWER 12 – 24 V DC” port (power supply)
7
Removing the Corona process from the mounting bracket
Loosen both clamping screws
1
on the mounting bracket using a 6 mm hex
wrench.
Remove the
Corona process
2
from the mounting bracket.
Fig. 14
2
1
Removing the Corona process from the mounting bracket
1
2
3
