Zeiss CONTURA, Руководство по эксплуатации

Страница: 104 / 158

Safety during the measuring operation
7-8
61211-1310402 CONTURA
– Heavy machine tools
– Transporters
– Presses
Measuring force for qualification
NOTE
Different qualification methods are available in the measuring software.
For some qualification methods, the measuring force has to be consid-
ered. Please see the user guide for the measuring software.
Batch measurement mode
NOTE
If the constant presence of the operator during batch measurement
cannot be guaranteed, the relevant safety regulations for unattended
operation must be observed. Access to the CMM by unauthorized per-
sons must be prevented by appropriate measures.
Observe the following regarding the batch measurement mode:
– Only authorized persons may work with the CMM.
– The set-up man must instruct the operator as to the operating posi-
tion of the CMM.
– During automatic measurement runs, the control console must be
placed outside the danger zone of the CMM.
– The control console must be equipped with a sufficiently long con-
necting cable to ensure that the CMM can be operated from all sides
if necessary.
You are even more flexible if you use the wireless control console.
NOTICE! The wireless control console must be inserted in
the docking station during automatic measuring runs.
– All existing safety equipment must be used. Make sure that no one is
in the danger zone.
– For more information on the safety equipment, please refer to the
separate “Installation site requirements” brochure.