Zeiss CenterMax, Руководство по эксплуатации

Страница: 106 / 166

7-6
Measuring operation
61211-1020202 CenterMax Operating Instructions
For further information, please refer to the
➤
Operating instructions
for the measuring software.
Collision protection
All probe systems provide complete collision protection for the probe
head and probe in the setup mode.
After collision
If the quill, probe head or probe collides with an obstacle and the
drives are switched off, proceed as follows:
• Eliminate the cause of the collision.
• Reactivate the drives on the control cabinet.
• Turn the rotary switch clockwise approx. 90° and hold it in this
position until the indicator lamp above lights up.
Initializing the CMM
If the drives cannot be switched on, the CMM has to be reinitialized.
For more information on the initialization procedure, please refer to
the
➤
Operating instructions for the measuring software.
If the quill or the probe head collides with an obstacle, the guideway
and other components of the CMM may be damaged. In this case,
perfect measuring operation cannot guaranteed.
• If measurements are not possible after a collision, call a ZEISS ser-
vice engineer or our hotline.
After a collision, the probe must be recalibrated and the workpiece
position (w position) must be determined again.
Axis clamping with VAST probe system
With the VAST probe system, axes can be clamped or unclamped.
Clamping or unclamping can be carried out via the measuring soft-
ware and the control console.
Probe system Protection
VAST probe system – Complete protection of the probe
head and adapter plate
– Complete protection of the stylus
in the setup mode
NOTE
NOTE