Zeiss Axiovert 5 digital, Инструкция по эксплуатации

Страница: 10 / 56

2 Safety | 2.2 General Safety Information ZEISS
2 .1.3 Optical Risk Grouping
According to EN 62471 sources of optical radiation are classified into risk groups subject to their
potential photobiological hazard. Sources are classified into the following four groups according
to hazard, based on the emission limit as well as permissible exposure time before hazard ex-
ceeded.
Risk group Description
Exempt No photobiological hazard.
1
2
No hazard due to normal behaviourial limitations on exposure.
No hazard due to the aversion response to very bright light sources or
thermal discomfort.
3 Hazardous even for momentary exposure.
The following table lists the risk grouping of the available light sources/illumination units accord-
ing to the mentioned standard:
Light source/Illumination unit Risk group
Axiovert 5 digital 1 (low risk)
2 .2 General Safety Information
This document must be read before commissioning in order to ensure safe and uninterrupted op-
eration. Pay particular attention to all listed safety notes. Make sure, that
§
the operating personnel has read and understood this manual, associated documents and
particularly all safety regulations and instructions, and applies them.
§
the local and national safety and accident prevention regulations must be observed, as well as
the applicable laws and regulations in your country.
§
§
§
§
this document is always available at the place of use of the microscope.
the microscope is always in perfect condition.
the microscope is secured against access by unauthorized persons.
maintenance and repair work, retrofitting, removal or replacement of components, as well as
any other intervention in the microscope not described in this document, may only be carried
out by the manufacturer ZEISS or persons expressly authorized by ZEISS to do so.
2 .2.1 Requirements for Operators
The microscope, components, and accessories may only be operated and maintained by autho-
rized and trained personnel. The microscope may only be used in accordance with this document.
If the microscope is not used as described, the safety of the user may be impaired and/or the mi-
croscope may be damaged.
Any unauthorized intervention or use other than within the scope of the intended use shall void
all rights to warranty claims. The regional regulations on health protection and accident preven-
tion must be observed at all times and during all work on and with the microscope.
1 0 Instruction Manual ZEISS Axiovert 5 digital | en-US | Rev. 1 | 431030-7021-101