Zeiss Axioscope 5, Инструкция по эксплуатации

Страница: 196 / 204

10 Accessories and System Expansions | 10.17 Assembling the Tube Lens Turret ZEISS
10.17 Assembling the Tube Lens Turret
Prerequisite ü The microscope is switched off.
ü The tube is removed (see Assembling the Intermediate Plate for Analyzer Slider [
}
195] ).
Procedure 1. Unscrew the tube lens (accessible from the bottom). Use the included ring tool.
2. Insert the tube lens turret's dovetail ring into the tube mount.
3. Tighten the clamping screw.
4. Mount the binocular tube.
Proceed in the reverse order for removal.
10.18 Assembling and Adjusting the Magnification Changer 4x
1
2
3
Fig. 108: Assembling the magnification changer
1 Magnification changer 2 Retainer nut
3 Camera port of the photo tube
Prerequisite ü The microscope is switched off.
Procedure 1. Remove the camera, camera adapter [
}
184] or the dust protection cover from the camera
port
3
of the photo tube.
2. Mount the magnification changer
1
on the camera port.
3. Adjust the magnification changer.
4. Tighten the retainer nut
2
.
5. If required, adjust the locking power for the magnification modules stop position. Use the
screw located on the bottom of the magnification changer housing. The screw is labeled
with a white circle.
6. Mount the camera on the camera port of the magnification changer. Use the appropriate
adapter.
Proceed in the reverse order for removal.
196 Instruction Manual ZEISS Axioscope 5, Axioscope 5/7 MAT | en-US | Rev. 13 | 430035-7344-001