Zeiss AxioCam ERc 5s, Руководство пользователя

Страница: 58 / 64

9 Troubleshooting | 9.2 Labscope
58 AxioCam ERc 5s | V 1.0 en
Problem Cause Solution
The image has severe noise. The amplification (gain) is set too high. Reduce the gain and increase the
exposure time instead.
The image is too dark or too
light. AET / AGC (automatic exposure time /
automatic gain control) has not been
activated Activate AET / AGC and select
Continuous mode or manually adjust
the exposure time so that the setting is
correct for the current light situation.
Monitor connected via
HDMI / DVI does not display
an image. The camera is not delivering a signal,
or signal is not compatible with the
monitor. Monitor switches to stand-by mode:
Ensure that the camera has been
switched on for at least 30 seconds
and the LED lights up green. Check the
plug connections on the camera and
monitor. Monitor displays an error
message that after switch-over to
1080p resolution the signal is outside
the monitor specifications. The monitor
may not support a 1080p30 signal.
Hold down the
C AWB
buttons on the camera body for two
seconds to return the camera to
720p60 resolution. If the remote
control is available, press the
Input
button to switch between 1080p30
and 720p60.
The camera forgets the
settings (e.g. manual white
balance, resolution) if the
power supply is disrupted. Settings were not stored. If settings have been made for regular
use, they must be saved before
disconnecting the power, see chapter
Setup User Menu [
}
42].
Camera otherwise behaves
abnormally. The camera may have been brought
into a non-intended state. Restore all default camera settings via
the OSD menu or by pressing the
C AWB buttons on the
camera for two seconds. The camera
will then restart and should be in a
normal state.
9.2 Labscope
Problem-solving notes for the use of the camera in conjunction with the network /
WLAN and Labscope app are to be found separately at the Zeiss website
www.zeiss.com/microscope/community .