2 Safety | 2.1 Intended Purpose
ZEISS
2 Safety
2.1 Intended Purpose
The product is a high definition microscope camera for color imaging. It is suitable for use as an
accessory for educational and routine microscopy in laboratory environments and for use by
trained laboratory personnel. The camera has been designed to be used in the field of light mi-
croscopy for general observation, routine work, and simple applications in which a sufficient
amount of light is available.
The camera should only be used for training and research. The images / videos from this camera
must not be used for the direct generation of diagnostic results.
2.2 General Safety Information
This document must be read before commissioning in order to ensure safe and uninterrupted op-
eration. Pay particular attention to all listed safety notes. Make sure, that
§
the operating personnel has read and understood this manual, associated documents, and
particularly all safety regulations and instructions, and applies them.
§
the local and national safety and accident prevention regulations must be observed, as well as
the applicable laws and regulations in your country.
§
this document is always available at the place of use of the product.
§
the product is always in perfect condition.
§
the product is secured against access by unauthorized persons.
§
maintenance and repair work, retrofitting, removal or replacement of components, as well as
any other intervention in the product not described in this document, may only be carried out
by the manufacturer ZEISS or persons expressly authorized by ZEISS to do so.
2.2.1 Requirements for Operators
The product, components, and accessories may only be operated and maintained by authorized
and trained personnel. The product may only be used in accordance with this document. If the
product is not used as described, the safety of the user may be impaired and/or the product may
be damaged.
Any unauthorized intervention or use other than within the scope of the intended use shall void
all rights to warranty claims. The regional regulations on health protection and accident preven-
tion must be observed at all times and during all work on and with the product.
2.2.2 Safe Operating Condition
If circumstances occur which impair safety and cause changes in operating behavior, the product
must be shut down immediately and a ZEISS service representative should be informed.
The product may only be operated if the operating conditions are adhered to.
§
Do not operate the product until you have completely read and understood the entire docu-
mentation.
§
Ensure conditions and take measures to prevent the build up of electrostatic charge on the
workplace.
Instruction Manual ZEISS Axiocam 105 color | en-US | Rev.2 | 426555-7010-001
8
