Zeiss Axio Examiner, Руководство по эксплуатации, Страница: 57 / 96

START-UP
Axio Examiner Microscope basic setting Carl Zeiss
M60-2-0003 e 05/2012 57
3.4.4 Setting the lock-in resistance of the
5x reflector turret
Only for Axio Examiner.D1 and .Z1 micro-
scope top parts.
The lock-in resistance of the 5x reflector turret is
freely adjustable. Proceed as follows:
•
Remove the binocular tube (see section 3.1.3).
•
Pull the closing plug (Figure 3-46/
1
) out of the
upper microscope part.
•
Turn the adjusting screw (Figure 3-46/ 2 ) using a
ball head screwdriver until the desired lock-in
resistance is set.
•
Insert the closing plug again (Figure 3-46/ 1 ).
•
Put on the binocular tube (see section 3.1.3).
3.4.5 Setting the actuating rod
Only for phototubes 425521-9020-000 and
425521-9000-000.
You can adjust the motion of the actuating rod
used for toggling between eyepieces and camera
output. Proceed as follows:
•
Remove the phototube from the upper
microscope part (see section 3.1.3).
•
Lay down the phototube safely with the lower
side turned upwards.
•
Set the motion step using the screw (width
A/F 1.5) (Figure 3-47/
1
) located on the lower
side.
•
Put the phototube on the upper microscope
part (see section 3.1.3).
Figure 3-46 Setting the lock-in resistance
Figure 3-47 Setting the actuating rod