START-UP
Axio Examiner
Installing standard components
Carl Zeiss
M60-2-0003 e 05/2012
41
•
Press the spring lever (Figure 3-22/
5
) at the heat sink, and put the heat sink (Figure 3-22/
1
) over the
burner.
•
Check for correct fit, and release the spring lever (Figure 3-22/
5
).
•
Insert the bulb holder into the lamp housing, and push it in until it locks into place. Tighten the
clamping screw (Figure 3-21/
1
).
•
Write down the counter reading shown at the hours-run meter (transformer). Replace the burner
when it has reached its nominal useful life of 100 hours.
Attaching the HBO 50 illuminator
3.1.14.2
•
Attach and align the HBO 50 illuminator
(Figure 3-23/
3
) at the connector socket
1
) in the stand top part, and
tighten the clamping screw (Figure 3-23/
2
).
•
Connect the HBO 50 connection cable to the
transformer, and connect the transformer to a
mains outlet.
•
Use the power button at the power-supply unit
front side to switch the HBO 50 illuminator
either on or off. The lamp will ignite
automatically when switched on.
Figure 3-23 Attaching the HBO 50
Содержание Axio Examiner
