- 5 -
11.
Set STATIC ANGLE
Enter menu and move to
Static Angle
with pressing + or - and then press enter .
Now you can set static angle with pressing + or - (in 0.1deg steps) and then press enter .
More information's about static angle you can find in section 15.
12. Set
COMPENSATION
It is compensation of signal delay from pickup to spark plugs. You can check this delay with
stroboscope lamp. Without this compensation, ignition advance angle decreasing with rising
revs.
This compensation helps that advance angles in ignition curve are real (more accurate).
How to check, if compensation is correct:
First you must set flat ignition curve. Then measure with stroboscope lamp, if mark at
flywheel moving when changing revs. If mark moving then you must change compensation
delay.
Change Compensation:
Enter menu and move to
Compensation
with pressing + or - and then press enter .
Now you can change compensation delay with pressing + or - and then press enter .
13. Set
PULSE
WIDTH
It is output pulse width (duration) in us. It affect on CDI triggering. Recommended setting is
200us or 100us.
Enter menu and move to
Pulse Width
with pressing + or - and then press enter .
Now you can change pulse width with pressing + or - (in 100us steps) and then press
enter .
14.
Set REMOTE SW
Enabling or disabling external switch for changing ignition curves while riding.
Enter menu and move to
Remote SW
with pressing + or - and then press enter .
Now you can enable or disable external switch with pressing + or - and then press enter .
