Zebex z-3101, Руководство по программированию

Страница: 71 / 71

Advanced Handheld CCD/Laser Scanner 65
P
ROGRAMMING
G
UIDE
Appendix 5: Header And Trailer
Introduction
The Header and Trailer section allows you to append a header and/or a trailer to every
message transmitted via the serial ports, USB or the keyboard port. There is no
restriction in selecting header or trailer characters as far as the sum of the lengths of
header and trailer is not greater than 10 digits.
1. Scan ”Start of Configuration”.
2. Select either header or trailer you are going to program by scanning the
corresponding label.
3. Scan the character(s) you want from the ASCII table to set as header or trailer. (Be
sure to enable full ASCII code 39 option before you start)
4. Read “Set, Confirm to save this setting (required for reading full ASCII table and
length setting)” to confirm your choice into memory.
5. Scan “(CP05) Function key emulation enable” if a function key is being
programmed.
6. Scan ”End of Configuration”.
Example
If you need to set 'TAB' and '@' as prefix, please follow the steps below.
1. Scan “Start of Configuration”.
2. Scan “(HT01) Header (Preamble)”.
3. Scan “Full ASCII ---HT Function key-----TAB”.
4. Scan “Full ASCII ---@”.
5. Scan
“
Set, Confirm to save this setting (required for reading full ASCII table and
length setting)” to save this setting.
6. Scan “(CP05) Function key emulation enable”.
7. Scan “End of Configuration”.