– 16 –
– 17 –
entire car against electrical fire hazards, you must insert a main-fuse (holder) within the first 30
cm after the battery. Do not insert the fuse until all the wiring work is completed!
Ground cable
Route the ground cable to the processor. A very close point of the chassis ground to the terminal
of the processor is preferable. The ground cable should have the same cross-section as the positive
(„+12V“) power cable! The contact-point on the car chassis must be solid and clean, i.e. free from
rust or paint etc.
Remote cable
Connect the "REM" terminal with the "Rem"-Output of the signal source.
RcA Interconnect & Remote wire
Carefully run the audio signal interconnects and the remote turn on wire from the head-unit or
dashboard to the processor. As mentioned before, the audio signal cables should be routed
completely separate from the power cables. Connect the remote (turn on/turn off) lead to the
respective input terminal of the processor and to the remote output of your head-unit. Connect the
RCA plugs to the respective line outputs of your head-unit and to the inputs of the processor.
Remote control
Find a well place in the near of the driver seat and there mount the Remote Control. Be sure that
the Remote Control does not intefere with sterring wheel or the driving itself at all.
Inital Power-On
If the processor is securely mounted, and all wiring is connected and double checked, you can
re-insert the fuse into the fuse holder of your power cable. Turn on your head unit and check for
a flawless playback of music.
Amplifier
Subwoofer
Midrange
Speakers
Amplifier
ZBP-1PRO Manual D+E.indd 17
21.08.2007 9:40:34 Uhr
