4. Hardware Installation
The following sections in this chapter describe how to install XA-623AH
Module
4.1. Installation Overview
XA-623AH
wireless module is design for Access Point, Router, and so forth.
4.2. Safety Recommendations
The safety guidelines are as follows:
λ
Keep the board area clear and dust-free before, during, and after installation.
λ
Keep tools away from walk areas where you and others could fall over them.
λ
Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains, that
could get caught in the board.
λ
Wear safety glasses if you are working under any conditions that might be
hazardous to your eyes.
λ
Do not perform any action that creates a potential hazard to people or makes
the equipment unsafe.
λ
Never attempt to lift an object that is too heavy for one person to handle.
4.3. Maintaining Safety with Electricity
Warning: Before working on a board or working near power supplies, unplug the power
cord on AC units; on DC units, disconnect the power at the circuit breaker
.
Follow these guidelines when working on equipment powered by electricity:
λ
Do not work alone if potentially hazardous conditions exist anywhere in your
work space.
λ
Never assume that power is disconnected from a circuit; always check the
circuit.
extension cables, frayed power cords, and missing safety grounds.
λ
If an electrical accident occurs, proceed as follows:
–
Use caution; do not become a victim yourself.
–
Disconnect power from the system.
–
If possible, send another person to get medical aid. Otherwise, assess the condition of
the victim and then call for help.
–
Determine if the person needs rescue breathing or external cardiac compressions;
then take appropriate action.
4.4.
Installing a
XA-623AH
λ
Remove the
XA-623AH
module from its protective packaging.
λ
Avoiding Electrostatic Discharge
Before you install the
XA-623AH
module, ground yourself by touching a
piece of metal to avoid electrostatic discharge (ESD). You should also
take the following precautions to prevent damage to the XA-623AH
module:
λ
Keep the
XA-623AH
module in its antistatic-shielded bag until
you are ready to install it.
λ
Handle the
XA-623AH
module by its edges.
λ
Ensure the connector is connected to above Model’s board tightly.
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements,
the antenna used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
