zBoost
®
PRO 7500 ZBC745SL-CM Manual
5
Power Requirements
The Base Unit can be plugged into a standard 2-prong 110 VAC receptacle using the included
power supply. The power supply consumes less than 10W (less than 0.2A).
Important Reminders:
An exterior mounting mast has not been provided. Using at least 1.5” PVC pipe or a J-pole
(available from zBoost, part YX014) is suggested should one be needed.
Installing Your zBoost Signal Booster
Outdoor External Antenna
FIRST: Placement of the External Antenna
Choosing the best location for the External Antenna provides the best performance and the largest
area of improved signal. Choose a location for the External Antenna using your cell phone to
determine the area of strongest signal - typically found outside, above the roofline or in an attic. The
antenna must also remain at least 3 feet from any metal objects such as pipes, metal siding, A/C
unit etc. and at least 15 vertical feet above the Indoor Antenna.
The YX699 Signal Meter (available separately) provides signal strength information. It can be used
with its supplied whip antenna to find the best location for antenna mounting with the strongest
received signal. It can also be connected to the directional antenna to aim the antenna for
maximum received signal. Contact zBoost to obtain a YX699 Signal Meter.
Mounting of Antenna
1.
When you have determined the location of the strongest signal, install the antenna to a
mast (not provided). Outdoor J-pole Antenna Mounting Bracket, YX014 is available at
www.zBoost.com. Loosely connect the antenna to the mast to allow the antenna to be
reoriented for strongest signal. Take special care in aiming the External Antenna in the
direction of best signal. If you are unsure of the nearest tower location of your wireless
provider, see”Antenna Aiming” on page 7 for detailed instructions.
2.
After installing the External Antenna to a mast or pole, connect RG-6 coax cable to the
External Antenna and run to the Base Unit.
