Wi-Ex
i
YX600 Series Installation Guide
Read First Before Installing the YX600 Series
Before unpacking this box, verify that your phone operates on the frequency
band supported by this product.
-
The YX600-CEL will enhance your in-building coverage for local
provider networks operating at the 800MHz (Cellular) frequency.
-
The YX600-PCS will enhance your in-building coverage for local
provider networks operating at the 1900MHz (PCS) frequency.
(NOTE) The YX600 Series is not compatible with iDEN, Nextel, SMR or ESMR
frequency services.
To verify that your phone will work in conjunction with the model
purchased
,
please follow these four simple steps:
1)
Unpack the Base Unit and the Base Unit power supply only
.
2) Connect the power supply to the Base Unit and plug it into an outlet. All of
the lights will flash for several seconds and then the Power light should be
solid green.
3) While standing about 1 foot away from the Base Unit, turn on your cell phone
or make a call. If the Signal light begins flashing green, you can proceed
with the installation of the system. If it flashes red, move your phone further
away from the Base Unit (typical for GSM) and retry.
4) If the Signal light does not flash green, try to place another call with your cell
phone directly touching the unit (typical for CDMA cell phones). If the Signal
light still does not flash green, your cell phone may not be compatible with
the model purchased. Contact Wi-Ex technical support at 1-800-871-1612
for further assistance.
Note:
The YX600 Series is fully automatic. The Install, Signal, and
Power lights on the Base Unit are not buttons. There are no
buttons to press on the Base Unit.
