Zass ZTWD 12E B, Руководство по эксплуатации

Страница: 4 / 16

3. FIRST USE
4. OPERATION
- Before connecting the appliance to the power source, leave the appliance in an upright position
approx. 2 hours. This will reduce the possibility of a malfunction of the cooling system caused by
handling the appliance during transport.
- Check that the water drain plug in the appliance is leaking or damaged.
It is necessary at first use or if the appliance has not been used for a long time follow the following
steps:
a) do not connect the appliance to the mains.
b) Fill the water tank of the appliance with potable water. Wait 5 min. until the water fills all the
internal connection hoses of the appliance.
c) press the hot water tap on the appliance for as long as water flows, then let the tap turn off.
d) connect the appliance to the mains. It is necessary to wait for a period of time for the water in
the appliance to reach the operating temperatures, approx. 10 min. for hot water and about 40 min.
for cold water and you will complete the commissioning process of the appliance.
e) disconnect the appliance from the mains. Continue to drain the water from the taps, alternatively
cold-hot, so long until the water runs out.
Note: Use a large vessel for this operation.
f) drain the remaining water from the tanks of the appliance by unscrewing the drain plug of the hot
water tank behind the appliance. After draining the appliance, replace the drain plug cap by screwing.
g) Install the water bottle on the appliance and leave it for 1 min.
h) Press the hot / cold water taps and allow water to flow through both taps.
i) The device is ready for first use.
- Ambient temperature: 10 - 36 ° C
- Atmospheric pressure: 86 - 106 kPa
- When using water cans with ultra-pure water, distilled water, remove the label from the cap of the
can, and when installing the can on the appliance, the plastic rod in the can holder of the appliance
will open the can and at the same time seal the can of water.
In the cold water tap there are no additional requirements or conditions.
4
NOTE:
The appliance is cleaned and sanitized after the manufacturing step of the appliance, but if
there is a problem with the taste of water, pour 2 tablespoons of baking powder into the appliance’s
cold water reservoir and add drinking water. Fill the tank with water and repeat the first-use steps,
except to stop the operation of hot water to prevent deposits of baking powder in the hot water tank.
2. KEY TO MACHINE PARTS (Page 2)
A/B
A/B
A/B
A/B
A/B
A/B
1
5
2
6
3
4
- Water bottle holder;
- Hot water power indicator;
- Cold water power indicator;
- Hot water tap;
- Cold water tap;
- Waste water tank.
On the back of the device, in
the top right position, there
are 2 switches (ON / OFF):
- for hot water (red);
- for cold water (green);