Zass ZKG 01 W/B, Руководство по обслуживанию

Страница: 5 / 13

2. Aim the 4 holes in the back of the machine to the 4 hooks on the wall bracket and push it on,
and then slide into the slot to click on, as shown below.
3. Fix the wall bracket lock piece onto the bracket with screws, slide the lock piece into the
locking slot on the back of the machine, and then tighten up the screw, as shown in the picture
below.
Note:
Prior to the drilling , make sure there is no cable or other pipelines on the wall to
avoid damage.
Remember
that the screws on the wall
shall be
fixed and firm to ensure the
safety install
ation
of
the
electric heater
o
n the wall. Please note the safe distance
mentioned below.

During
installation
, the heater
must be maintained sufficiently safe distance
from
combustible
materials and gas and away from water.

During
wall
-
hanging installation,
keep the
installation height from the ground
greater than
15
cm. Hanging
-type
heater
shall
be no less than 50 cm
away
from the ceiling
.
Ⅴ．
Operation notice

Make sure the heater shell, line and power plug are intact.

Check the rated voltage in the model label of the heater is in line with that of the outlet.
Power outlet requirements are: voltage 220V, frequency 50Hz, bearing current ≥ 10A.
Do not
power the heater on until the requirements are met.
Wall Bracket
Lock Piece