PROFESSIONAL TWO-WAY RADIO
11
Install & Remove the headset /
programming cable
Open (not remove) the SP / MIC cover, and
then plug in the accessory firmly into the
side jack.
If you want to remove the accessory, unplug
it gently and close the SP/MIC cover.
Charging the Battery
Only use the supplied or approved charging adaptor to charge
the battery. The charger’s LED indicator will indicate the charging
status. The battery can be charged by itself or when connected to
the radio.
CHARGE TIME is approximately 6 hours from flat to full.
OPERATING TIME is approximately 30 hours with a fully charged
battery if used typically on a 5:5:90 duty cycles.
1.Plug in the mains adaptor to a wall socket.
2.Connect the adaptor’s output plug into battery’s side charging
jack.
3.The adaptor’s LED will light RED indicating that the battery has
started charging.
4.The LED will change to GREEN when the battery is fully
charged.
5.Pull out the adaptor plug from battery DC jack and unplug from
the wall socket.
Note:
1. Make sure the radio is switched off during charging or the
charging time will be longer.
2. Li-ion batteries do not have memory so they can be recharged
at any time. There are a limited number of charge cycles that
the battery can handle, typically 500-700 times. To get the
maximum use of the battery, only recharge when getting flat. If
an almost full battery is recharged, the charging cycles are not
optimized.
PROFESSIONAL TWO-WAY RADIO
12
3. When the battery charge goes flat, the radio’s LED will flash a
red light and the radio will keep reporting “Please charge the
battery”.
Содержание ZA-758
Страница 1: ......
