WARNING!
•
Fully charge the worklight before storing for long periods. Keep recharging
every few months or the battery may go faulty.
•
Do not recharge this worklight with any other adaptors other than those
supplied with the unit.
•
Do not dispose of the worklight in a fire or ordinary waste.
•
Do not operate the worklight in high temperature, hazardous or explosive
environments.
•
Do not subject the worklight to strong impacts.
•
Do not disassemble or modify the worklight as it contains protective
devices which, if damaged, may cause the battery to heat or ignite.
•
Do not leave the worklight in direct sunlight or hot spaces for extended
periods.
•
Never short circuit, reverse polarity, disassemble, damage or heat the
battery packs over 100°C. If an exploded Li-ion battery does ignite, it will
burn more violently if it comes into contact with water or moisture. Never
put water on a burning Li-ion battery only use a fire extinguisher.
•
This worklight is rain and splash proof only but not submersible. If the
worklight gets submersed in water, immediately dry the worklight and do
not use for a few days. Water damage is usually irreparable.
Operation:
The button is located at the back of the unit. Position 1 is high mode with 100%
power and position 2 is low beam mode with 30% power. Middle mode is OFF.
•
Operating Time: 2 modes
High beam 4 Hours
Low beam 12 Hours
The Zartek ZA-445 worklight has an Aluminium lightweight housing for the light
with powder coated steel H stand for firm positioning on flat surfaces. Beam
direction can be adjusted by 360° horizontally and 90° vertically. Fix the worklight
head position by tightening the 3 hand screws.
•
Reflector for Uniform Light Dispersion
•
Beam Colour: white
•
Beam Angle 120 Degrees
•
Beam distance approx. 300 meters, Wide Area