4
1. The supplied Li polymer battery pack is already installed in the handset. To replace, press
down the lock button
16
and slide open the battery door, take out the battery pack and
disconnect from socket
18
.
2. With the handset switched on, place it into the charger stand.
3. Plug in the supplied AC switching power supply into an AC outlet and connect its output plug
to the DC jack
21
located at the back of charger stand.
4. The charging indicator
20
should light up red during charging process. Adjust the position of
6. Now the unit is ready for operation. Either take out the unit or keep
placing it in the charger stand will cause no damage to the battery. In the latter case, when
the battery is being consumed and voltage falls to a certain level, the charger stand will
automatically charge up the battery. The segments inside the icon P will flash in turn
whenever the unit is under charging.
CAUTION : BESURE THE BATTERY IN HANDSET IS RECHARGEABLE TYPE BEFORE YOU
PLACE IT IN THE CHARGER STAND, OTHERWISE EXPLOSION MAY RESULT.
16
18
TO AC OUTLET
21
20
5. The battery pack should be fully charged up within 4 hours when used for the first time. All
segments inside the icon P will shown up and remain steady.
Handset
handset in charger stand in case this indicator does not light up. During charging, the
segments inside battery level icon P will flash in turn.
CDP-805 manual_3.pdf 4 27/5/2017 12:21 PM