Zares ZTrak, Руководство пользователя

Страница: 13 / 31

© Copyright 2007 - ZARES (ZL1CVD Amateur Radio Equipm ent Supplies) – all rights reserved
Page 13
Configuration
Profiles
The OpenTracker can store two separate configuration profiles. The profile currently being shown is selected by clicking
on the tabs at the top of the window labeled ‘Config 1’ and ‘Config 2’.
Setting Profile Conditions
The OpenTracker processor will switch between configuration profiles when certain conditions are met. The seven tests
are:
1. Altitude as indicated by a GPS receiver.
2. Speed as indicated by a GPS receiver.
3. Temperature as reported by the on-board temperature sensor
4. Voltage as reported by the on-board voltage sensor
5. ADC Input is the value of an analogue signal connected to pin JP7. The possible values are 0 to 255, corresponding
to a range of 0 to 5 volts.
6. Jumper detects if JP1 is high or low. Pulling this pin low (JP2) sets the On condition.
7. GPS Fix considered invalid if it has been more than 20 seconds since the last valid position was received from the
GPS unit.
The checkboxes to the left of each condition actives the test. The two radio buttons at the top test any or all of these
conditions. The comparison button in the middle can be either ‘>’ (greater than) or ‘<=’ (less than or equal to). Clicking on
the button showing the comparison operator toggles it between these two settings.