ZappBug ZappBug Heater, Руководство пользователя

Страница: 13 / 22

13
Remove the battery door on the back of the thermometer probe by sliding the
door down and insert one AA battery.
1. After inserting the battery, the remote sensor LED indicator will light for 4
seconds, and then fl ash once per minute, thereafter. Each time it fl ashes, the
sensor is transmitting data.
2. Close the battery door.
on the thermometer base station. See Figure 2.
3. Place the wireless thermometer probe in the deepest, most insulated part
of the item being treated. Allow the ZappBug Heater to run for 60 minutes or
longer after the temperatures reaches 120 ° F.
4. If you are not present while the unit is running, we advise setting the timer to
8 hours, however this is generally more time than required for the ZappBug
Heater to reach 120 ° F and maintain it for one hour.
5. If the base station does not update, view troubleshooting tips on page 18.
While in search mode, the reception icon will fl ash
Thermometer Probe Set Up
1
2
3
1. Wireless Transmitter LED
2. AA Battery
3. Battery Door
Thermometer Probe
Use & Operation
(continued)