10.
Properly mount the MD38-B2 pre-cut baffle into the cabinet with the screws and
washers from step 2. The tweeter hole should be on the opposite end as the
already installed input cup. Do not over tighten the screws when mounting the
baffle. Rather give them a turn every day or so until the gasket has fully
compressed. The baffle is now correctly installed.
11.
Pull the remaining wires through the appropriate cutout holes in the baffle. You
have marked the wires with a marker or tape in step 4. At this point, take a look at
how the internal wire has arranged itself inside the cabinet. A small amount of left
over Acousta-Stuf or some that is accessible in the cabinet may be used to ensure
the wire will not rest, rub or tap against any hard surfaces or other drivers in the
cabinet.
12.
Carefully solder the leads to each driver. Observe polarity. (If you are questioning
your soldering skills, we have provided quick connects to make this step a little
easier. Once you crimp the quick connects on the stripped ends of the wire, press
them onto the appropriate tabs of each driver. We highly recommend that you
make this connection permanent by soldering the quick connects to the driver tabs
at this time.)
13.
Take note of how you want the screw alignment to look when the drivers are
mounted in the cabinet. Line up the drivers according to your preference in the
baffle recess and drill pilot holes with a small drill bit. Mount the drivers into the
cabinets with the provided screws. We have provided you with your choice of
Phillips head or Socket head screws. Note: Bring the screw head just short of
contact with the driver flange, and then tighten each screw slowly allowing the
gasket to compress and the driver to become flush with the baffle.
14.
Your ZRT 2.5 Way kit is now complete.
15.
Plug, play and enjoy!
Detailed information on this kit is available at
www.madisound.com
and
www.zaphaudio.com
