zapco SLX-2, Руководство пользователя

Страница: 7 / 11

7
Input Mode: Selects between two-channel or four-channel
input. The 2CH (in) position uses the X1 input to feed
both crossover sections. In the 4CH (out) position, the
X1 input only feeds the X1 crossover section and the X2
input feeds the X2 crossover section. This feature is
useful if front/rear “fade through” capability is needed, or
if you wish to create 24dB one-way or two-channel
bandpass configurations.
Special Configurations
Creating a 24dB one-way filter: Use the X1 input as your input
and set the input mode switch to 4CH (out). With a short
SymbiLink

cable, connect the X1 Output to the X2 Input.
The X2 Output will be your output. In this configuration, X1
and X2 must both be matching as highpass or lowpass. The
X1 Freq Range switch cannot be used (it must be in the “X1”
or in position) and the “X1-HI” option on the Output 2 switch
should not be used. Adjust the X1 Freq and X2 Freq to the
same crossover frequency.
Creating a two-channel bandpass filter: Configuration is the
same as above with the following exceptions. X1 should be
selected as lowpass and X2 should be highpass. The Freq
Range switch may be used. Adjust the X1 Freq and X2
Freq controls to the desired individual crossover points.