zapco DSP-Z8 IV II, Руководство пользователя

Страница: 7 / 30

The DSP-Z8 IV Control Systems
The new Z8 IV II DSPs can be controlled by your PC or by iOS and Android smart devices.
Because of the restrictions of screen size, there are a few things that are easier using the PC
GUI, so we will cover that first. We recommend the first setup be done by PC. In addition to
the PC and Mobile controls that allow a complete system setup, the DSP-Z8 IV II units also
come with an included Dash Remote.
1.
Unlike many remotes, the remote of the DSP-Z8 IV series is an integral part of the device.
First it is a volume control, which is a must when you are using a full gain digital input. Secondly,
the volume control is also a control for the bass output. If you are using Channels 7/8 for the
bass, as most users do, you can push the volume control in one time and the bass level will
begin to flash and it becomes an output level control for channels 7/8.
2. The readout normally gives you the volume level. If you push the Volume knob one time it
gives you the bass level. If you don’t make any adjustments for about 15 seconds, it will return
to reading volume.
3. If you push the Volume knob 2 times you will see only MODE and the mode number flashing.
Mode is the memory preset. In mode function, the volume knob cycles through the presets
that have been stored.
Dial to the preset you want the push the volume knob once to get input source selection or
twice to return. Any preset positions not used will not show up in the MODE choices.
4.
If you press the volume knob three times you will enter Source Selection and you can
choose Main, BT (Bluetooth Streaming), Aux, or Opt (Optical) by turning the volume knob to
the input you want.
1 2 3 4