Insect Trap
Wall Sconce
Item No:
605WS30WD /WH /GD /BK
Wattage:
30W
Input:
120V
Dimensions:
25” W x 7½” D x 6¾” H
Usage:
Indoor
Replacement Bulb:
#60515WATT
Replacement Glue Board:
#517RGB100
SAFETY PRECAUTIONS
CAUTION:
This equipment gets HOT. Make sure
all flammable/combustible materials are set away
from this equipment.
• Do not operate any appliance with a damaged cord or plug,
nor after the unit malfunctions, is dropped, or is damaged in
any manner.
• To reduce the risk of injury, close supervision is necessary
when the unit is used near children.
• Only use attachments recommended or sold by the
manufacturer.
• Do not insert fingers or foreign objects into the unit.
• Do not put this product in water or other liquids.
Do not place the insect zapper where it can fall into water.
• Do not abuse the power supply cord or carry product by the
cord. Keep cable away from heat, oil and sharp edges.
Never allow the cable to hang in front of the cover.
• Do not
unplug by pulling on cord. To unplug, grasp the plug,
not the cord.
• Always disconnect the product from the power source when
not in use, before maintenance, and when cleaning.
• Always unplug before replacing the lamp.
Replace bulb with same type and rated wattages.
• Store the unit indoors and out of the reach of children when
not in use.
INSTALLATION GUIDELINES
These precautions should be followed at all times.
Failure to follow these precautions could result in
injury to yourself and others.
TO REDUCE THE RISK OF ELECTRIC SHOCK,
THE PLUG MUST BE PLUGGED INTO AN
APPROPRIATE OUTLET THAT IS PROPERLY
INSTALLED AND GROUNDED. CONSULT
A QUALIFIED ELECTRICIAN IF IN DOUBT
WHETHER PROPER GROUNDING EXISTS.
1. Remove all packaging and protective film from the insect
zapper. Do not rest the unit on surface without continuing
to support it. It will not stand on it’s own.
2. Select a proper location to hang the unit. The unit must NOT
be installed where dangerous concentrations of flammable
or explosive substances are likely to be present in the air.
3. Connect the appliance to main power.
4. The unit will be ON once it is connected to an electrical
source. There is no separate ON/OFF switch. The bulb will
take a few minutes to light up completely. The insect zapper
is designed for commercial usage such that the unit
could remain ON 24 hours a day.
PROPER GROUNDING
This item is provided with a three-pronged grounding plug.
The outlet to which this plug is connected must be properly
grounded. If the receptacle is not the proper grounding type,
contact an electrician. DO NOT, under any circumstances, cut
or remove the third ground prong from the power cord or use
any adapter plug.
BEFORE OPERATING ANY EQUIPMENT, READ & FAMILIARIZE YOURSELF WITH THE USE & SAFETY INSTRUCTIONS
ZAP N TRAP would like to thank you for purchasing this equipment. It’s important to save these instructions for future reference.
