To clean the detergent drawer it is necessary to
remove it from its site.
Open the drawer.
Press the catch down-
wards as described in the
graphic and pull it out.
Remove the top part of
the additive compartment
to aid cleaning.
Flush it out under a tap, to
remove any traces of ac-
cumulated powder.
Make sure that all washing
powder residue is re-
moved from the upper and
lower part of the recess.
Use a small brush to clean
the recess.
Close the drawer and run
the rinse programme with-
out any clothes in the
drum.
CLEANING THE INLET HOSE AND THE VALVE
FILTER
3
1
2
45°
20°
EMERGENCY DRAIN
Because of a malfunction, the appliance cannot
drain the water.
If this occurs, do steps (1) through (8) of 'Cleaning
the drain filter'. If necessary, clean the pump.
When you drain the water with the emergency drain
procedure, you must activate the drain system
again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser.
2. Start the programme to drain the water.
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
remaining water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the emergency
drain procedure.
5. When the drain pump is empty, install the inlet
hose again.
WARNING! Make sure that the
temperature is higher than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
16