Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the figure.
Slacken the screws and insert the scraper under the
screw head, then re-tighten the screws.
Door reversal
Unplug the appliance before all operations.
To reverse the door, proceed as follows:
1. Remove the ventilation grill (D).
2. Unscrew the bottom hinge (E).
3. Remove the door by releasing it from the top
hinge pin (A).
4. Remove the pin and the washer (A+B) from the
top hinge (C), then mount these on the opposite
side.
5. Remove the two plugs, to reveal the holes for the
hinge pivots, and remount them on the other
side.
6. Replace the freezer door.
7. Screw down the bottom hinge (E) on the oppo-
site side by using the screws previously
removed.
8. Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side.
9. Re-assemble the ventilation grill (D).
10.dismantle the handle and reassemble it on the
opposite side.Cover the holes left open with the
plugs contained in the documentation pack.
The door can be aligned by adjusting the top hinge
by slackening the nut with a 10 mm spanner and
then proceeding as shown in the Figure.
Warning:
After having reversed the opening direction of
the doors check that all the screws are properly
tightened and that the magnetic seal adheres to
the cabinet.
If the ambient temperature is cold (i.e.
in Wõnter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the
gasket or accelerate this process by heating up the
part involved with a normal hairdrier.
Reversing the quick-freezing com-
partment door
Unscrew the closing prong support (A). Unscrew the
two hinges (B) and remove the door. Turn the clos-
ing prong support and fix it to the other side of the
quick-freezing compartment. Reverse the door and
the hinges and mount them on the other side of the
compartment. Check to see that the door closes cor-
rectly.
PR153
E
F
D
F
F
F
C
B
A
PR19
D162
PR74
A
B
15